Simplex 5009-9311 Bath/Shower Pull Stn and 11 similar items

Simplex 5009-9311 Bath/Shower Pull Stn The 5009 Code, Emergency, and Bath/Shower Stations are single-gang, wall-mounted devices used to signal high-priority level calls on the EZ Care system. Stations must be connected to either a Model 5009-9801 or 5009-9707 Non-Audio Room Controller, a 130.1200 or 130.1600 Audio Room Controller, or a 5009 93xx Series Audio Patient Station. The Simplex 5009-9311 station can be configure to be fully supervise. The Simplex 5009-9311 stations provide a lever for call placement and reset as well as a call assurance LED. When the lever is push into the DOWN position; the call is latch mechanically at the station and the red LED call assurance indicator is activate to indicate the call has been place. The call is cancel at the station by pushing the lever into the UP position. If a supervision scheme is use, the room controller reports a fault condition if the wiring between the controller and the station is severe, shorted to the ground, or shorted to power. Each station features an integral, jumper selectable, 150 Ohm end-of-line resistor. Also, the Simplex 5009-9311 Bath/Shower features a water seal gasket. Features / Specifications Waterproof Bath/Shower Station for use in High Moisture Areas Easy Call Placement and Call Cancellation Call Status is Indicate at an LED on each Station and by Visual Study of Lever Position Item is NEW *Box Opened For Picture* Item comes exactly as pictured. If it is not in the picture, it does not come with the item unless stated in the description. You may not receive the exact unit pictured, but one in similar condition. Check compatibility with your system. We are not responsible for incompatibility or improper installation. 20% RESTOCKING FEES AND SHIPPING WILL BE CHARGED. IF ITEM IS FUNTIONAL OR INCOMPLETE. An Important Message Regarding USPS Tracking Numbers Due to high volume of shipments sent through USPS, Tracking numbers get recycled on occasion. This means, when you receive the notificaiton that your package has been shipped via USPS, and you try to track the status of the package, it may show your package was Delivered even though the label was just generated. Please don't panic, the solution to this issue is to wait until the Post Office scans the label, then the tracking information will update accordingly. Please let us know if you have any questions. Your feedback is extremely important to us! If you are satisfied with our service please take the time to give us positive feedback. We tremendously appreciate it! We strive for your complete satisfaction. Likewise, if you have any issues, please contact us first, and we promise we will do our best to satisfy your needs and solve the problem. If we resolve your problem, we kindly ask you to still leave us positive feedback. Your kindness will be extremely appreciated!