Rokonet Lunar RK200RC0000A Remote Control and 15 similar items

Rokonet Lunar RK200RC0000A Remote Control PRE OWNED/ MIGHT BE OPENED BOX/ LISTING AS USED BECAUSE THERE ARE SOME SRATCHES ON THE UNIT The Rokonet / Risco Industrial LuNAR RK200RC0000A Remote Control is a handheld bi?directional infrared programmer used to set up and test Industrial LuNAR ceiling detectors, not a security system keyfob for arming/disarming. What it is used for It communicates with Industrial LuNAR DT detectors (e.g., model RK200DT00xxA) to adjust settings and run diagnostics from ground level, so you do not have to access the detector on the ceiling. It allows both reading status (voltages, noise levels, troubles) and writing configuration parameters (microwave sensitivity, ACT mode, LEDs on/off). Power and basic operation The remote is powered by two CR123 lithium batteries and automatically powers down about 60 seconds after the last keypress to save energy.? You turn it on with the power key, point it at the LuNAR detector, and use its LCD and keypad to navigate menus and send commands.? Main functions available Self?test / diagnostics: Runs a LuNAR self?test and displays input voltage, microwave (MW) signal and noise level, and PIR channel DC/noise levels for channels 1?3.? Microwave sensitivity: You can increase or decrease MW sensitivity in steps (MIN, 25%, 50%, 65%, 85%, MAX, TRM) and then confirm to transmit the new setting to the detector. ACT mode control: Enables or disables ACT (Anti?Cloak Technology) mode, in which the detector temporarily switches to MW?only detection when room and body temperatures converge or during cloaking attempts. LED control: Enables or disables the detector?s LEDs for walk?testing or for normal ?dark? operation, with the current LED status shown on the first LCD line.? Enabling remote control on the detector For LuNAR units wired in relay mode, a specific dipswitch combination (e.g., DIP 6 OFF, DIP 7 ON) and a low level on the detector?s ?RC? terminal must be set so the detector will accept commands from the remote. When installed on a bus system, additional steps are required so bus?connected LuNAR detectors can communicate with the remote; these are detailed in the Industrial LuNAR installation guide. SHELF: 58 SA