*Keep in mind 3D printed parts will have texture. Think of them like model car parts. May need a light sanding, A xacto knife trimming small supports or paint if you wish. Usually 1 side was attached to the printer bed and it may be the roughest. Lightly sand and usually fine. Thanks again for your interest.

~~~DESCRIPTION~~~ New 3D printed Block Set for Stomper 4x4s..

Colors close but not exact. See pics ~When you receive your 3D printed Parts they may have a small amount of Elmer's Glue on the back wash with warm water for use. Zoom in and judge for yourself. Most of these I stuck a battery in to see if it works but otherwise are as found condition. Sold as is. Condition is Used.

Shipped with USPS

Vintage 80s Stompers like most Electronics can stop working during shipping. Typically you can put a fresh battery in them and tap them on the bottom and they will start working again. Sometimes the solder will come loose which is also easily fixed. Battery not included. Smoke free home!